Name: jason zheng
Tel: 0577-61510353
Fax: 0577-61510353
E-mail: info@chance-electric.com
E-mail: yqchux@126.com
Add: Floor 8 No.63.Yueqing electric zone liule road,Yueqing,Zhejiang,China,325604
Skype: zheng.janson
QQ:
3572813688
Product name : Open Frame Power Supply PS-35 35w 12v 24v 5v On Board Type SMPS
Item : 201661184114
|
Details: | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Open Frame Power Supply PS-35 35w On Board Type SMPS
|
Specification | Model | |||
PS-35W-5V | PS-35W-12V | PS-35W-15V | PS-35W-24V | |
DC output | 5V 6A | 12V 3A | 15V 2.4A | 24V 1.5A |
Wave and noise | 100mVP-P | 120mVP-P | 150mVP-P | 200mVP-P |
Inlet stability | ±0.5% | ±0.5% | ±0.5% | ±0.5% |
Load stability | ±1% | ±0.5% | ±0.5% | ±0.5% |
Efficiency | 78% | 81% | 81% | 85% |
VOLTAGETOLERANCE | ±3.0% | ±2.0% | ±2.0% | ±2.0% |
AC input voltage range | 85 ~ 264VAC 120 ~ 370VDC | |||
AC CURRENT (Typ.) | 0.4A/115VAC 0.2A/230VAC | |||
INRUSH CURRENT (Typ.) | COLD START 40A/230VAC | |||
LEAKAGE CURRENT | <0.5mA / 240VAC | |||
OverLoad protection | 105%~150%hiccup mode ,auto-recovery | |||
Setup,rise,hold up time |
5 ~ 24V:1200ms, 30ms 48V:1200ms, 75ms at full load |
|||
Withstand voltage | I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC | |||
Isolation resistance | I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC | |||
Working temperature | --10 ~ +60°C (Refer to output load derating curve) | |||
WORKING HUMIDITY | 20 ~ 90% RH non-condensing | |||
Safety standards | Design refer to GB4943,UL60950,EN60950 | |||
EMC standards | Design refer to GB9254,EN55022 classA | |||
DIMENSION | 101.6*50.8*24mm (L*W*H) | |||
PACKING | 0.124Kg;96PCS/12.9Kg/0.8CUFT | |||
NOTE |
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature. 2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor. 3. Tolerance : includes set up tolerance, line regulation and load regulation. 4. The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives. |
Related Products : |